The cost-effective TP Series amplifiers are packed with solid and convincing arguments for the professionals seeking quality, reliability and value. TP Series is a project based on a mono-block approach offering an all-in-one power module that contains the entire amplifier assembly excluding only the toroidal transformer. This topology offers the best quality and reliability avoiding effectively several inter-connections between the different circuits. The transformer location on one side, allows to shorten to the minimum the cooling tunnel built by the power heat sinks, the fan and the intake and exhaust grills.
| Model Name: | TP3K3 |
|
Output Power 1 kHz 2 Ω | 2 × 1650 W |
| 4 Ω | 2 × 1450 W |
| 8 Ω | 2 × 1000 W |
| Bridge at 4 Ω | 3300 W |
| Bridge at 8 Ω | 2900 W |
| Output Circuity: | Class H, 3 steps |
| Frequency Range (power bandwidth ± 0.5 dB): | 20 Hz – 20 kHz |
| THD (20 Hz – 20 kHz): | < 0.05 % |
| S/N Ratio: | 110 dB |
| Damping Factor (20 Hz – 500 Hz at 8 Ohm): | > 350 dB |
| Voltage Gain (selectable): | 32 dB |
| Input Sensitivity: | 2.25 V |
| Input Impedance: | 20k ohm (balanced) / 10k ohm (unbalanced) |
| Protection: | Soft-start, Turn-off transients, Muting at turn-on, Over-heating, DC, RF, Short-circuit, Open or mismatched loads, ICL Clip Limiter (LDTP2K5 & LDTP3K3) |
| Controls: | On/Off, Volume, Bridge/Stereo configuration switch |
| Indicators: | Power, Clip, Protection |
|
Connectors: Input: | XLR |
| Output: | Neutrik Speakon |
| Cooling System: | 2 x continuously variable speed fan, rear to front |
| Power Supply: | AC~230V / 50 Hz |
| Power Consumption Full Load: | 9.9 A |
| Dimensions (W x H x D): | 483 × 88 × 215 mm |
| Weight: | 13.5 kg |
